How to use and adjust the airbrush kit

1. Before use, connect the air inlet of the gun body to the compressed air source (the compressed air must be filtered by the oil-water separator before entering the gun), connect the air pipe, and adjust the pressure of 0.45-0.5Mpa.

2. Loading, mix the paint thoroughly with the corresponding thinner (the blending paint purchased directly does not need to add thinner) and adjust the viscosity to 17-24S for the No. 4 Ford Cup (the time for the cup to leak the paint), the paint with impurities needs to be Strain it, and then introduce the paint into the paint can.

3. Fog width adjustment: Rotate the fog width adjustment screw clockwise until it is tightened to obtain a circular cross-section fog width. If you rotate it counterclockwise, you can obtain the fog width of the oval (sector) cross-sectional width you require. And adjust the length according to actual needs.

4. Adjustment of airbrush kit spray volume Turn the spray volume adjustment screw clockwise to reduce the opening stroke of the needle plug, and the paint output will decrease accordingly. Rotate counterclockwise to gradually increase the spray volume.

5. Air volume adjustment Turn the air volume adjustment screw clockwise, the air volume gradually decreases, and counterclockwise, the air volume gradually increases.

6. When you use it, move the trigger slightly to open the air valve, but the needle plug is not opened, and the compressed air is sprayed from the airflow nozzle. At this time, you can blow off the dust on the coating surface, and then continue to move the trigger backward. , the spray nozzle sprays paint mist.