How to Maintain Your Airbrush

1. Always check the needle valve, gasket, and air valve gasket sealing book for leakage. If there is leakage, it should be replaced in time. Oil should be often applied to the sealing gasket to make it soft and facilitate sliding.
2. Do not disassemble the airbrush at will. When disassembly is necessary, it should be noted that the rectangular parts should not be stuck with garbage and paint, and the air cap and nozzle should not have any damage. After assembly, adjust to the original state, and pull the trigger to test the air and paint. spray effect.
3. The thread of the air cap of the gun, the adjustment knob of the paint volume and the air adjustment knob, etc., should be oiled frequently to ensure flexible movement. The spring of the spray gun thimble and the air valve should also be lubricated to prevent rust and facilitate sliding.
4. Before using the airbrush, a comprehensive inspection should be carried out to ensure that the airbrush is in good condition before it can be used.
5. When using the airbrush, avoid colliding with the coated object or falling to the ground, otherwise it will cause permanent damage and cannot be used.
6. When suspending work, the nozzle of the airbrush should be immersed in the solvent to prevent the paint from drying and solidifying and blocking the nozzle, but the entire airbrush should not be completely immersed in the solvent, which will damage the sealing gaskets of various parts and cause leakage. The phenomenon of gas and paint leakage.
7. The airbrush should be cleaned in time after use, otherwise the paint channel will be blocked (especially 2K paint), and it will be difficult to clean in the future, or even unusable. After cleaning the spray gun, connect the paint pipe and the compressed air pipe for test spraying, and adjust the fan surface of the spray gun. The fan angle of the manual air spray gun is 70-80 degrees. If there is any problem, report it for maintenance in time.

In the maintenance of the spray gun, the most important thing is to clean it in time after use, which will help prevent the failure of the spray gun.