Introduction of airbrush pen

The AirBrush Pen is a device powered by the rapid release of liquid or compressed air and can be used directly with paint. Generally, there are three adjustable buttons that can rotate on the spray gun, they are: pressure adjustment knob, flow adjustment knob, spray adjustment knob. Here's how to use the AirBrush Pen.

1, when we use before. It is necessary to connect the inlet interface of the spray gun body with the compressed air source (the compressed air must be filtered through the oil-water separator before entering the spray gun), and connect the air pipe, and adjust the pressure of 0.45-0.5mpa.

2, filling the paint with the corresponding thinner and the viscosity is adjusted to paint no. 4 Ford cup 17-24s (cup paint leakage time), there are impurities of the paint need to filter, and then the paint into the paint tank.

3. Fog amplitude adjustment Turn the fog amplitude adjustment screw clockwise until it is tightened to get a circular section fog amplitude. If you turn it counterclockwise, you can get the fog amplitude of the oval (fan) section width you require, and adjust the length according to the actual needs.

4. Rotate the ejection adjustment screw clockwise to reduce the opening stroke of the needle plug and reduce the amount of paint. On the contrary, the amount of ejected gradually increased.

5. When you use it, move the trigger slightly to open the air valve. But when the plug is not opened, compressed air will shoot out of the jet nozzle. At this point, you can blow the dust off the coating surface, and then continue to pull the trigger back.